I'm all set to finish replacing the rear turn-signals.
Well, almost! I've decided (finally) where they are going to go, I've checked out how I'm going to extend the wiring on the new indicators and I've even removed the fender tail light and indicators.
So what IS the hold-up this time?
I don't want to cut off the connector from the stock indicators in case I ever want to re-use (or sell) them. So I thought the easiest solution would be to buy new connectors, solder or crimp them on and away I go.
So, I went on to a Harley forum and asked where I could buy replacement connectors.
No-one seems to know. So now I've got yet another wait untill I can source these little bits of plastic.
Well, almost! I've decided (finally) where they are going to go, I've checked out how I'm going to extend the wiring on the new indicators and I've even removed the fender tail light and indicators.
So what IS the hold-up this time?
I don't want to cut off the connector from the stock indicators in case I ever want to re-use (or sell) them. So I thought the easiest solution would be to buy new connectors, solder or crimp them on and away I go.
So, I went on to a Harley forum and asked where I could buy replacement connectors.
No-one seems to know. So now I've got yet another wait untill I can source these little bits of plastic.
No comments:
Post a Comment